HomeElegoo Neptune 4 ProGetting Started

First-Time Setup & Assembly

beginner#setup#assembly

First-Time Setup & Assembly

  1. Attach the gantry to the base and tighten the screws evenly.
  2. Check the eccentric nuts on the wheels: the bed and toolhead should move smoothly with no wobble. Adjust a quarter turn at a time.
  3. Check the power supply voltage switch (if present) matches your mains — 230 V in Europe.
  4. Connect the cables, power on and run auto leveling from the touchscreen.
  5. Print the included test model.

Tip: Write down the printer's IP address from the network settings — you will use the web interface (Fluidd/Mainsail) a lot.